Gongyi Xinqi Polymer Co., Ltd.Wastewater FlocculantPROCESS SAMPLE DOSSIER
SAMPLE → SCREEN → SEPARATE → VERIFY
SEND A PROCESS SAMPLE →
Application-specific purchase briefs

Flocculant for Oily Machining Wastewater: Qualify After Primary Conditioning

Select flocculant for machining-coolant wastewater by defining oily phases, emulsion conditioning, solids, primary chemistry and separator-specific acceptance.

SAMPLE
process state
POLYMER
matched preparation
RESULT
separator evidence
Dissolved air flotation system with flocculated wastewater, recycle piping and a surface skimmer
Application-specific purchase briefs
DOSSIER INDEX01Specify the purchase duty02Describe the incoming liquid03Establish the upstream condition04Judge water, oil and solids handling05Read a conflicting trial result06Agree the acceptance record07Request the relevant sample or offer
01

Specify the purchase duty

Spent or diluted machining coolants can differ greatly in oil, fine solids and formulation. A flocculant offer must identify its role after any required emulsion destabilization or primary conditioning. Do not assume a high-molecular-weight polymer alone will resolve every stable oil-in-water system.

Keep the wastewater source, supplied product identity and required separation result together. An application name narrows the enquiry but does not establish a universal grade or dose.

02

Describe the incoming liquid

Record coolant source, dilution, age, pH, temperature, conductivity, solids and relevant oil measurements. State whether different coolant formulations or cleaning discharges are combined before treatment.

Sample handling can change the oil and solids distribution; preserve the collection point and elapsed time with each test.

03

Establish the upstream condition

Reproduce the plant primary chemistry and mixing before comparing coded flocculant grades. Use relevant no-polymer or incumbent references and keep the active-dose basis clear.

The test procedure supports controlled comparison without claiming that every oily stream needs the same chemical combination.

04

Judge water, oil and solids handling

Match the comparison to flotation, settling or the installed separator and record the appropriate outlet and residuals measurements. Inspect any downstream filtration or waste-handling burden.

A visually separated layer is incomplete evidence for discharge, reuse or waste classification. Those responsibilities remain with the validated treatment and site approval process.

05

Read a conflicting trial result

If a candidate clears suspended fines but leaves a persistent emulsion, raising flocculant dose has not been shown to solve the primary separation problem. Review conditioning chemistry before selecting another grade.

Repeat the reference and leading conditions when differences are close to sampling or measurement variability. Keep untested conditions visible in the qualification rather than extending one favorable observation.

06

Agree the acceptance record

Buying checkEvidenceAcceptance
FeedCoolant and oily-phase historyActual matrix tested
Primary stepConditioning and sequenceFlocculant role defined
OutputWater and recovered materialCombined handling accepted

Retain the coded sample, preparation, active basis and measurement timing. Preserve failed conditions alongside the accepted range so later deliveries can be compared with the actual evidence.

07

Request the relevant sample or offer

Send coolant and wastewater information, current conditioning, separator and target results. Request a scoped sample comparison with a clear boundary between primary treatment and polymer-assisted separation.

Send the flocculant sample and quotation request and review product and supply requirements with Gongyi Xinqi Polymer Co., Ltd.. Confirm the offered identity, documents and commercial scope before ordering.

WhatsAppEmail